Whitfield Replacement Parts Support

Whitfield Stove Parts

Pellet Stove Parts, Repairs, and Troubleshooting
From Industry Experts

Troubleshooting the Blowers:

Blowers Keep Running When you turn off your Whitfield stove, both blowers should continue operating during the cool-down cycle until the low-limit switch shuts them down. If the blowers don’t stop running, the low-limit switch is likely stuck in the closed position. To diagnose the issue: Bypass the switch or use a multimeter to check […]

Pellets will not ignite:

When working properly, the igniter draws hot air from the convection blower through the igniter housing and over the hot igniter probe to light the pellets. If the igniter probe heats up in the stove but fails to ignite the pellets, air flow in the firebox may be restricted. When pellets do not ignite, make […]

Stove shuts off unexpectedly:

This issue is often caused by problems within the burn chamber, the temperature sensors, or the photoeye. These are the areas that we suggest checking. A dirty burn grate can cause the stove to shut down because it inhibits pellets from burning. Clean the burn grate by using the grate scraper tool to chip away […]

The stove will not feed pellets:

Several factors can cause the feed system not to start. First, visually check the feed system. Start with the hopper to see if the stove has run out of fuel. Next, thoroughly check the auger for a jam or obstruction which could be preventing the auger from turning. If you see an obstruction you can […]